Riders Inner Hoodie

• color black

Windproof and warm" in wetsuit material.
Inner hoodie for motorcycles that can also be used as outerwear.

Windproof and warm at the same time, elasticity for any body action.
An inner jacket with a hood that concentrates the best parts of a wetsuit for activities in water, where heat escapes 20 times faster than in air.

[Protects your torso from the wind that mercilessly steals your body heat.]
The temperature can be as low as minus 3.6 degrees Celsius at 60km (10 degrees Celsius and 45% humidity) in the motorcycle world.
Even more important than the temperature is the driving wind, which increases in proportion to the speed.
Prevents wind from blowing into the mid-layer and prevents body heat from flowing out into the open air.
It is a thermal item for motorcycles.

■2.5mm chloroprene material
Adjusted for motorcycle comfort and thermal performance to reduce the burden of long hours of riding.
I selected a thin 2.5mm thickness.

■Material properties of chloroprene
Chloroprene (synthetic rubber) contains minute independent air bubbles, so it is resistant to air and water and has excellent airtightness.

[It stretches and doesn't stick.Bendable and prone elasticity.]
Chloroprene is a good choice for motorcycle innerwear because it has a stretch rate of up to 40%.
Whether you are leaning out like a motard or leaning in like a motorcycle, the jacket will stretch and follow your boldest movements.

[up and down.Dimensional settings to accommodate seasonal changes in motorcycle attire.]
Riders Inner Hoodie can be used as outerwear by itself.
The sleeve length is not too short, and the hood is large enough to prevent wind from blowing in, while the hem fits the body to prevent body heat from flowing out.
It can be worn as an outer layer in the fall and as an inner layer in the winter, depending on the season.

■Stretchy raglan sleeves
By stretching the entire arm, we were able to maintain a uniform fit and provide an extremely high amount of movement around the shoulders.

■Length to prevent the back from showing
The back does not protrude even in the foreground posture.
Minimal overhang from outer jacket.
We have set up a special size to meet the specific requirements of motorcycles.

[3 layers + 1" thermal protection for motorcycles.]
A base layer that absorbs and diffuses perspiration, which is also necessary to protect against the cold on a motorcycle.Mid-layer for warmth.Outer layer to prevent outer wind".
The Rider's Inner Jacket is worn between the mid-layer and outer layer to block wind gaps.
It enhances the effect of "water absorption, heat retention and windproof" of each layer.

[features of each part]
■Food
Adopted a small silhouette hood to reduce the gap between the outer layer and the flap when riding a motorcycle.

■Cuff adjuster
The hook and loop fastener prevents the wind from flowing in through the gap between the wrists.

■Large Windstopper
A large 50mm wide stopper prevents the wind from entering through the front zipper.

■Flatlock Stitch
Flat and elastic sewing with no thick seam allowance.
The material has a high degree of adhesion and is suitable for motorcycles with a lot of action.

■Zipper pocket
Three zippered pockets for the bike, so you can use the pockets even after you take off the outer jacket.

■Arm logo
The arm logo is visible from the outside of the arm.*Printed only on the left sleeve