- It's just like changing a light bulb.There is no problemRead More
- Perhaps it is because the Scooter has a low power generation rate, but I feel that the Halogen bulb has a wider beam range and better visibility.This might be better with a slightly better Halogen bul...Read More
- Installation was easy. It was brighter than I expected.Read More
- I originally used M&H Mats Stripe Halogen bulb 12V35/30W Clear, which was brighter than OEM, but still old mopeds are still dark.Since I use them for commuting, I decided to use LEDs for safety reason...Read More
- Installed on a Honda NSR80.The NORMALWhite heat bulbs in the NSR80 were very dark, so we replaced them with LED bulbs to make nighttime driving somewhat safer.If anything, it is not for the purpose of...Read More
- Used for GYRO CANOPY (TA03).CANOPY is bright anyway, partly because it is a two-light system.Light distribution is not bad.Now we are hoping for durability.Read More
- I have been using it for about a week.Light is M&H Maz StripeB2 on DMR-JAPAN Multi-reflector used for about 2 years. [Color] Clear (35/36.5w) This is a change fromDirect AC compatible, so it is also c...Read More
- The Halogen bulb was no longer working, so I decided to replace it anyway!I had previously purchased an LED that claimed to be an "explosive light" on the Internet, but it was the exact opposite, bein...Read More
- [How is it used?The Headlight Bulb of the LITTLE CUB that was given to me was out of order, so I searched for a replacement bulb to brighten it up.Was the one you received as per Image?A little longer...Read More
- I bought this product after looking for a Type LED Bulb that I could simply replace the bulb with.4.I used it for the headlight of ADDRESS V100 which was converted to 5-inches Bates Headlight. Since t...Read More
- It is now so bright that it is dazzling.Recommendation.Commendation for commuting to work and schoolRead More
- The headlight is dark and I had been holding back because I had read that Halogen bulbs would melt the lenses. I had to remove the Valve Reflector, but it can be removed by removing one screw from eac...Read More
- I'm useing for Honda Giorcub, but the headlight bulb was too long, and I cut the end. Not heating, not flashing. It1s very good for my bike.Read More
- I removed 3−4mm from the last conical section to avoid putting it in Original's Light. Glass is still touching, I think 5mm is better.Socket fits, brighter than OEM, light flickers while idling.Read More
- It flickered quite a bit. My Motorcycle does not have a Battery, so that may be the reason. Naturally, I don't recommend using LEDs in a battery reply.Read More
- [How is it used?Commuter Vehicle.Was the one you received as per Image?Heat Radiation Fin is long and the depth of the fin is too long, which is a disappointment because it hits the light lens hard wh...Read More
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING