* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
We use cookies to provide and improve our services. By using our site, you consent to our Privacy Policy including cookie. Learn more
It was not possible to install it with Pipe Handlebar of ClipOn. I have driven a total of about 1,000km in four trips, and there is no sign of loosening at this point in the pre-ride inspection. We store the vehicle with Seat cover over the eaves outdoors, but leave the Holder on. The degree of deterioration is an evaluation of the future. I don't think it's a good idea to have a messy Handlebar area, but once you get used to the navigation of a four-wheeled vehicle, you'll want one for two-wheeled vehicles as well.
I installed it to open Navigation on my mobile phone, but the price is cheap and it can be fixed with Firmly, and it is not difficult to see by vibration, etc.! It even comes with a Rubber to prevent accidental falls!View Detail
It is good immediately after buying it. The high rating on the other Reviews probably comes from the satisfaction right after installation. The problem is the feeling of use after one year of installation. This product, after about a year of continuous use, the RedLever on the back will stick and you won't be able to open and close it. This product made by DAYTONA, the usability itself is very good, so I bought the same product again after I couldn't use it once, but I couldn't use that one either due to the same phenomenon after about 1 year of use. Again, the usability itself is very good. I'm very disappointed because if I could use it all the time I would give it 5 stars without complaint.View Detail
Every time I buy a new motorcycle, I buy a smartphone holder. Have you ever worn a similar one from MiKnowla or discontinued from MiKnowla. I bought it because it was from DAYTONA. The usability is still the same because of the similarity. It's easy to install on the vehicle, just temporarily fix it and adjust it in places and you're good to go! You can release it with the back Button Only.View Detail
I installed on honda Hornet 250.Looking good design & easy to fixing.As a fixing tool Allen key will along with catalog.Depending on handle size there are rubber gland (for clamp mount)along with parts.can be turn and adjusted vertical or horizontal .The clamp mount will fitted firmly to handle."dyatoma made in Japan " printed on camp .I'm using 165.3 x 76.8 x 10.1 mm phone.tightly clamp to the phone,little hard to put on ,but can be adjusted as a phone size.phone mount corner clamps are protected with sponge pad for avoid phone scratches.There are 2 white rubber band hang on with phone bracket, it's for put in your phone for safety.(avoid falling down)I will Recommended this for motorcycle enthusiast.View Detail
This item looks very promising in the pictures. I really liked the design.In reality It is very weak. It is made of a very weak type of plastic.I have seen cheap phone holders for 7usd that use better material.There are very important parts in this design that should be made of metal, but in this case those are made of thin plastic.From the outside It looks like the body is made of aluminum, but it is just a decorative sheet metal part.If I knew, I would not pay more than 12 usd for this product.On the other hand, the vibration damper doesn't seem to do much.The Handlebar clamp is made of aluminum, but because it is very thin, It looks like it will break if you tighten the screw too much.Don't use this holder on single cylinder bikes, because the damper is not effective enough.Be very careful when installing this product, because It is not made of strong material and it will break If you tighten the screws too much.It looks like It will not last much under the sun either.For 52usd I expected a sturdy well built phone holder.It doesn't look like it was made in japan because of the cheap quality.It is expensive, bulky and flimsy.Next time I will try with SP Connect.View Detail
It can be rotated 360 degrees (wrench required) and also has a tilt function from side to side.It is also very convenient to remove because it is a quick-release type. View Detail
Strong and stable. And easy to fit. You can tilt your smartphone in any angles you want. Adjust heights with pincers, facing with joint and rotation with cradle.View Detail
I ordered Smartphone Holder Wide for Motorcycle By: DAYTONA It design Looks very good and Strong I install on yamaha SR400 which SR400 name of the vibration when driving. But it does not show shivering. and It Very Easy to install to hand barView Detail
?attachment The CBR650R is mounted at the same position angle as the NORMAL. However, when the handlebar was cut to the Left lock, it interfered with the interior cover next to the Meter, so the interior cover was cut away. I also purchased a 45° angled banjo adapter for the mesh hose to accommodate the tension of the mesh hose. ・NORMAL (Reserve integrated horizontal master) Impressions of No complaints on public roads. Familiar feel and very easy to handle. However, when the brake is set to "hard brake," the rate of increase in braking force relative to the input seems to decrease, and the brake becomes more forceful. Radipon (Reserve separate body portrait master) Impressions of It was totally different from what I expected, my expectation was that it would feel like a Rear brake… It is really a mild and easy-to-handle radipon. On public roads, it feels like NORMAL! I wonder if it's because NORMAL is the same NISSIN? But I felt the radipon effect from Breaking a little stronger, and It can be hung up to a hard brake without effort. I felt trust that this could stop.View Detail
I purchased this for use with multiple Helmets. 。 Mount included with the BOLD. Microphone and speaker are not included and must be purchased separately.View Detail
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING