*Stomp Grip adhesive needs 24 hours to stabilize its adhesive strength.Full adhesion requires 72 hours.If you use the product before it is fully bonded, it may peel off or shift. *Please pay special attention to the use of stomp grips that are attached to the frame surface. *When driving a vehicle equipped with stomp grips, please wear clothing that does not allow your bare skin to come into direct contact with the stomp grips.If you drive with your bare skin in direct contact with the product, you may suffer from abrasions and other injuries. The adhesive used in Stomp Grip is very strong.If you remove the stomp grips forcibly, the paint may come off with them.To remove the Stomp Grip, heat it up with a heat gun or the like to reduce its adhesive strength, and then remove it. (It depends on the paint condition of the vehicle, but older vehicles need special attention) *We do not accept returns or exchanges after the package has been opened. *Because of the shared stock system with the store, there is the case that it is out of stock by the purchase timing regardless of the stock display.If the item is not in stock, we will order it for you. *Please make sure to check the year of your vehicle before ordering.
While most of the products are just a sticker to prevent scratches on the body, the Stomp Grip is a riding support gear that has evolved into a functional part to reduce fatigue. From the street to the circuit, it is highly supported in various situations. Originally developed elastomer material, strong 3M adhesive is used for the adhesive. The pad keeps its original gripping power without shifting even in hard riding scenes. MADE IN THE USA!
Stomp Grip is used by top racers and stunt riders all over the world. It is very popular in the circuit and the street in Japan. Stomp Grip users are increasing all over the world.
[stomping on stomp grips] 1. Clean the surface to be applied. (When using clear, please remove dirt and water stains with compound before starting work) 2. Degrease the surface to be applied. 3. Perform positioning. 4. Apply from the edge so that air does not enter.Peel off the backing paper while pasting. (If you use a clear sheet, apply it slowly and carefully, taking your time from the edge.It is possible to stick it beautifully without air entering.)
The adhesive of Stomp Grip needs 24 hours to stabilize the adhesive strength. Full adhesion requires 72 hours. If you use the product before it is fully bonded, it may peel off or shift.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
Because TankGrip has no other products to choose from, we can not compare and Motorcycle supplies are generally expensive so we do not want COSPA but it is expensive anyway. The GSX-R which I was riding in before was able to make a perfect Knee grip, but at S1000 RR it has almost no effect. It is not due to this product that the position to paste is limited because of Motorcycle Design, but it is a feeling that I honestly wear it by fashion rather than by function. Even if this product comes to me, I will not buy it but this time it will remain as raw.View Detail
I am a beginner at Motorcycle. After delivery, the first Custom? Haha I enter the air etc. I did not want to put a Small scratch on Tank Installing. Try it on ,,, Somehow Parenthesis nice ,,. I feel satisfied with feeling like! The price should be about 3, 4000 yen ~ Large I was satisfied!View Detail
I usually use Denim pants if it is Touring, because it is a human being only Leather pants when I merely run through the pass alone, the items of this line are mandatory Items.
I used SnakeSkin from TECSpecifications instead of looking at this item before. TECSpecifications looked good, but I could only affix it to Tank Parts and I did not receive much benefit. (I think that Tank Parts of S1000RR is not such a position that Knee grip is always available for ordinary Japanese people. If the sitting position is quite ahead you will be able to Grip, but I think that there are few people sitting in that position with SS) Compared to that, there are Parts that you put on the Side Panel part, and the anti-slip part is at the position where you grip in reality. Thanks to Denim pants I got a lot easier than before. At the time of wearing Leather pants, the seating position hardly gaps in hard braking. The only concern is that Damage to each Pants. Even at supplies shops etc. "Stomp punctures even in Leather pants" As I heard that, if such a thing happens too easily it will not be possible to consider replacement (lol
Regarding the pasting of goods, everyone seems to be right, it seems easy to get bubbles. As I knew about that in advance, I applied it carefully as it is, but after all I got bubbles somewhat. However, it disappears too much while using, it is better to stick it more than carefully, stick it many times, paste it, peel it off, paste ... or more carefully paste it in 1 or 2 times I think so.View Detail
Paste is easy if you position carefully! It is better to keep the car body vertical by Racing Stand etc. : Pair (for Left and Right) Hitoshi etc. I think you can stick it.
It was very effective for Jeans and Nylon pants, but I think that Leather has not much effect. Isle of Man etc.. But it is worn by many machines and it is a bit of disappointing part. The aggressiveness to Leather is considerably stronger than that, the new item of Dainese's leather suit knee portion is full of scratches with Circuit running 5 times. It seems that the seams also get frayed.
To Leather opponent "Mashi is better than nothing" I think that it would be better to think about degree. In the world of Race the Leather suit is a consumable item!
We recommend that you purchase it carefully considering your clothes, vehicles, and uses.View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!