[rear box size] Vertical: 33cm x width: 58cm x Depth: 45cm [Material] Rear carrier: Steel black paint Rear box: Reinforced ABS [Components] Pedestal, screw, etc.
Capacity: 48L Maximum load capacity of rear carrier: 3kg
*The bolts attached to the rear box may be too long when installing on some models.In this case, please cut the bolt short or prepare a short bolt.
Rear Carrier x 1 for PCX Two Colors Lens Rear Box Exclusive 48L x 1 Full set with base and screws required for installation. In addition, the set comes with a limited edition rear box inner.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
Very good, solid Carrier and Rear box. However, since Carrier's installation Bolt & Color is too long, the height of the front and rear are not matched, and a gap can be formed. I cut the color so that it would be my favorite height, and installed it with the hand Bolt. Also, fixed Bolt of Rear box mounting Bracket is abnormally long. As long as the Instruction Manual can be disconnected if it is long, but how is it. The length doubles but it is badly seen. Since it can not be helped, also use this Bolt Cut. The goods themselves are very good, the cospa is the best.View Detail
I attached it to PCX 125. I thought that it was a bit Large, but I thought that Helmet in is Small, Rear box, Large is doubling as Small I made this product. I tried using it, I think that it was good to make this Large Kimono.View Detail
It is good because it is normally usable, normally durable, and less expensive than famous Manufacturers.
But one drawback, or something to watch out for, is that
They are not compatible with Givi.
Givi and Kaeppa also have interchangeable mounting bases, so you can change only the box to suit your touring needs.
When I attach a WorldWalk box to a Givi base, it fits, but the bracket that holds it in place does not fit properly, and I can't get it to stay in place.
When I set the Mounting Base to WorldWalk, Givi's was still not working.
Then, remove the SpacerRubber from the base, attach the box, drill a hole from the bottom, and pass the bracket for the corrugated plate through it.
Just close it with Screw when you use it, and you are done. It should not come off easily.View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!