Fluid can be drained from the bleed area of the banjo bolt and air can be removed quickly.You can choose from a wide range of colors.(Some collars are not available due to bolt pitch.)
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
Recently viewed products
Ratings & reviews for this product or related products
I installed it on the upper side of the NINJA400's rear master. Rear brake piping can be long and complicated, especially on ABS-equipped models, which can make it difficult to bleed. Therefore, I installed this Air Free Banjo Bolt in anticipation of improving air extraction around the Rear master. It's easy to install:Remove brake fluid on the rear side, remove the rear master - upper Banjo bolt, then install this Air Free Banjo Bolt. (Crash washer is included in the kit.) Then inject Brake fluid and remove air. I tried this Air-free Banjo here. The result is probably OK. it is uncertain whether it is the effect of this Air-freeBanjo, but Fluid injection and air removal could be completed in Smooth without air bite. In the case of NINJA400, if you install the Air-free Banjo on the upper side of the rear master, it will interfere with the original plastic cover. Therefore, it is necessary to cut a part of the resin cover. I used a hot knife to cut the resin cover as shown in the photo.View Detail
Air bleeding work became easy, but Material : For Stainless Steel it feels a bit easier to loosen. I think that it is better to tighten further after installing it for a while. Breed also. It is good that Wrench is hard to lick, but on the contrary the fear of biting into Caliper. Also, Rubber cap has been disconnected with 2 detachments. I do not want to worry about Parts around Brake, so I'm inspecting it, but it's inconvenient in that sense. Material : Aluminum may be less expensive and cheaper.View Detail
Rear master (Gail) It is easy to use because it is used for Purchased this time with the addition of Sam Brake master. Air removal is much easier.View Detail
I was having a hard time bleeding the air out of the NisshinHorizontal TypeMaster Cylinder. When I used this Banjo bolt, air bleeding was finished without difficulty. The hose for air bleeding sticks firmly and does not come off easily.View Detail
Installed on brembo old Crab caliper. With the Caliper installed, the Bleeder Bolt is in a position where there is no way to turn it, so it's nice to have a product like this. This allows you to replace the Fluid without removing the Caliper. (You have to remove it to bleed air.)
The screw part is too long to fit on the OEM Banjo. Two Washer on top and bottom (Total Quantity):(1 Set of 4pcs.) I used it.View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!